Beef Soboro: An Easy ground beef Recipe for a Weeknight Dinner (2024)

FAQs

How do you cook ground beef hack? ›

Baking soda acts as a tenderizer for ground beef, keeps it moist during cooking, and encourages deep browning by raising the acidity level of the surface of the meat. Simply add 1/2 teaspoon of baking soda to 1 pound of ground beef for more tender meat with better browning.

The pre-crumbled steamer basket method was the one preferred in our Test Kitchen. Set pressure to high, and cook for about 6 minutes for one pound and about 10 minutes for two pounds. (To cook one pound of ground beef from frozen, set the timer to 30-40 minutes instead.)

Baking soda (Sodium bicarbonate). If you find the meat has a spongy texture aside from being very tender, then very likely the restaurant put baking soda (Sodium bicarbonate) in the marinade. The sodium in baking soda chemically reacts with the meat and make the meat very tender and soft.

Cook It Slowly

This is certainly true when it comes to notoriously tough cuts of meat like beef brisket and pork shoulder. Cooking these cuts of meat slowly, either by braising, stewing or grill roasting, is the best way to get these tasty cuts of meat meltingly tender.

Boiling ground beef is the best way to cook it so that it comes out in small, fine crumbles. Trust me, this is the secret to all those amazing tacos and pasta sauces at your favorite restaurant! It's also a healthier option, because the boiling process helps separate the fat from the meat, and it comes out quite lean.

Egg yolk acts as a binder and adds flavor

After forming it into a patty, he explains that the egg actually helps bind the meat together, and adds an incredibly rich flavor to the burger patty. As a good rule of thumb, it's best to add one yolk per pound of ground beef.

Heat the olive oil in a pan over. Add the beef and cook until it starts to brown on the bottom. Use a spatula or wooden spoon to break up the beef while stirring occasionally, being careful not to overmix the meat. Cook until there is no more pink and browned all over.

Fillers like breadcrumbs, rice, and beans are a simple, low-cost solution to stretch a pound of ground beef and your grocery budget. Depending on the ingredients you add, the filler will also enhance the flavor and reduce fat in your recipe.

When it comes to seasoning your ground beef, wait until after it has been browned and drained. Adding salt to raw ground beef pulls out moisture, drying the meat out and creating steam while it cooks, which prevents it from browning properly. The same goes for other seasonings, but for a different reason.

How do you make ground beef soft and tender? ›

Luckily, there is a handy little chemical that solves both of these issues. It's called “sodium bicarbonate,” but is known to most as “baking soda,” and adding it to your ground beef helps keep it tender while also speeding up the browning process.

There are a few methods, but this is the easiest way: Sprinkle 3/4 tsp baking soda (bi-carbonate soda) on 250g / 8oz sliced economical beef cuts. Toss with fingers, leave for 30 minutes. Rinse, pat off excess water.

Let the beef sear for a few minutes without moving it around. Once the beef has browned, break it into smaller pieces with a wooden spoon as it continues to cook until done.

Velveting is a simple process of using baking soda or a mixture of egg whites, cornstarch and oil to marinate and tenderize economical cuts of steak, chicken and other meats before cooking. Velveting meat softens fibers to reduce toughness and enhance juiciness for maximum flavor and tenderness.

Using a meat mallet (or kitchen mallet) to pound steaks helps soften and tenderize the meat. Simply place the meat in between pieces of plastic wrap or wax paper and pound it prior to cooking. If you don't have a meat mallet, you can also use a heavy kitchen tool such as a skillet, saucepan or rolling pin.